Sima XL-72 Guide de dépannage télécharger pdf (Page 5)

Unpacking the Screen

1. Remove all the items from box. Don’t cut the boxes too deep,

as this may damage the screen. (FIG 1)

Inating the screen

1. Remove the frame from the package. Unroll the

screen as shown at right. Be sure both bases are

facing the correct way. (Both air valves should be

facing the same direction.) (FIG. 2)

2. Plug the AC air pump into an AC power outlet.

NOTE:

POWER SUPPLY MUST BE 120V AC, 60 Hz. USE A

PROPERLY GROUNDED GFI OUTLET IF USING THE

PRODUCT OUTDOORS

3. Locate the air inlet/outlet valves. You will notice that

each valve on each base has two layers of seals that

cut o the airow. The outer seal is a threaded cap

that screws into place. (FIG. 3)

4. The inner seal is a rubber check valve designed to

hold in air when a certain amount of pressure is applied.

(FIG. 4)

FIG 1

FIG 2

FIG 3

FIG 4

Page 5

1 2 3 4 5 6 7 8 9 10 ... 13 14

Pas de commentaire

Sima XL-72 Guide de dépannage Page 5