Sima Smooth Start Series Manuel d'utilisateur

Model STP-600 Power Inverter Titanium Plus Smooth Start Series User’s Manual

page 10 Step #2: Wiring Inverter to 12 volt Power The power inverter requires connection to a standard 12 volt DC power source as found in most cars,

page 11 Temporary Wiring The power inverter comes with a set of jumper cables to attach directly to your battery terminals for temporary usage. For

page 12 Permanent Installation Figure 3, Wiring the STP-600 Installation Tip: To minimize electrical interference, keep the DC power cables as sho

page 13 Wiring Steps • Disconnect the positive battery terminal before doing any wiring to the inverter. • Using proper sized copper wire and prop

page 14 Advanced Installation Large inverters can draw high currents from your battery and charging system especially when used with appliances and t

page 15 Step #3: Testing the Power Inverter After you make sure the 12 volt power is wired properly to the power inverter, with nothing plugged into

page 16 Operation Equipment Power Usage It is important to use only products that draw less than the power rating of the power inverter. Use of produ

page 17 Some products draw a high surge current to start up. If the appliance does not operate and the inverter turns off, you may need a larger inver

page 18 Actual Current Draw Approximate 12 volt current draw is the load in watts divided by 10. Thus a 60 watt light bulb plugged into the inverter

page 19 Lights and Alarms POWER Indicator (Green) This light will turn on when the inverter is turned on and is operating normally. If this light goes

page 2 IMPORTANT: Sima Products Corporation does not authorize any products to be used in life support systems Date Purchased ________

page 20 Smooth Start The Smooth Start feature of the STP line of power inverters is designed to handle the power surge that is created when some appli

page 21 Light Status Chart Power Switch Power Light Beeper Fan Fault Light Mode Off Off Off Off Off Unit is off On On Off On Off Normal Operatio

page 22 Troubleshooting Problem Cause Solution Unit does not operate Input voltage is below 10 volts Attach to proper supply Fuse blown Determi

page 23 Product Specifications (Subject to change without notice) STP-600 Input 12 - 14 volts DC Input no-load current < 0.20 A Output type modif

Limited Warranty Sima Products Corporation (“Company”) warrants that if the accompanying product proves to be defective to the original purchaser in m

page 3 Safety Information IMPORTANT: Read all the Cautions and Warnings before installing and using the power inverter. The inverter must be properl

page 4 Table of Contents Introduction ...5 Key Features...

page 5 Introduction Congratulations on your purchase of a Sima Products Corporation power inverter. It provides 115 VAC anywhere you have 12V DC; in

page 6 Package Includes Inverter (Model STP-600) Cables with alligator clips This manual Needed for Installation (not included) Mounting hardware for

page 7 Overview of the Power Inverter The STP-600 power inverter is an electronic devices that converts the low voltage 12 VOLTS DC from a battery or

page 8 Installation Overview Install the power inverter using these three basic steps: 1) Mounting: Mount the inverter securely 2) Wiring: Wire t

page 9 Caution: The power inverter must be mounted securely in any type of moving vehicle. In an emergency situation, if the power inverter is not s